ColorDRIVE Control Box PCB

Control PCB for the ColorDRIVE's own ColorBUS system.

Can be used with ColorDRIVE one and ColorDRIVE 6 (one modulation channel only).

Can be used to manually set modulation voltage via potentiometer or external signal (depending on switch state).

Displays state of interlock, power reduction and ColorDRIVE sensor error.

Features a screw cage clamp connector for external interlock and modulation signal (interlock modes include: line break, line make and "to ground"-mode).

Comes with:

- 15cm flat ribbon cable

- ferrules

- interlock bridging cable

Specification

Connector in	1x 6pin Screw Cage Clamp Connector
Connection out	12pin, ColorBUS connector
Control options	Potentiometer for modulation, switch to choose between on-board modulation and external signal
Mounting	4x M3 screws
Dimensions	46mm x 35mm